| GENERAL |
| Type: | Amateur HF/VHF transceiver |
| Frequency range: |
TX: 10-160 m + WARC / 50-54 MHz
RX: 0.03-60 MHz
|
| Tuning steps: | 1 / 5 / 10 Hz (AM/SSB/CW)
10 / 100 Hz (FM) |
| Frequency stability: | ±0.03 ppm @ -10 to +60°C (14 to 140°F), after 5 minutes warmup |
| Mode: | AM / FM / SSB / CW / RTTY / Packet |
| Channels / memory management: |
99 regular
5 QMB
9 scan edge pairs (PMS)
Non-volatile EEPROM storage
(The antenna tuner memory requires a CR2032 lithium battery backup)
|
| Repeater shift / offset: | 10 m: 0-1 MHz in 10 KHz steps
6 m: 0-4 MHz in 10 KHz steps |
| Power supply: | 50, 13.8 and 5 VDC from external PSU (FPS-9000H) |
| Current drain / power consumption: | RX: Max 120 VA
TX: Max 1000 VA |
| Antenna impedance / connector: |
50 ohm / Four SO-239 + Two SO-230 (RX only)
(16.7-150 ohm HF and 25-100 ohm 6 m with ATU on)
|
| Dimensions (W*H*D): | 518*165*438 mm (20.4*6.5*17.3") |
| Weight: | 29 Kg (63.9 lb) |
| Other features: |
Data port. PS/2 keyboard jack. Direct I/O sound card connections. 32-bit IF DSP.
CAT control. CTCSS/PL. VOX. IP3 better than +40 dBm! Twin identical RX.
|
|
|
|
|
| RECEIVER SECTION |
| Receiver system: |
Triple conversion superheterodyne
1st IF: 40.455 MHz (VFO-A) - 40.450 MHz (VFO-B)
2nd IF: 455 KHz (VFO-A) - 450 KHz (VFO-B)
3rd IF: 30 KHz (24 KHz for FM)
|
| Sensitivity: |
AM (10 dB S+N//N, 6 KHz BW)
0.1-1.8 MHz: 3.2 uV
1.8-30 MHz: 2 uV
50-54 MHz: 1 uV
FM (12 dB SINAD)
28-30 MHz: 0.5 uV
50-54 MHz: 0.35 uV
SSB/CW (10 dB S/+N/N, 2.4 KHz BW)
0.1-50 MHz: 2 uV
HF ham bands: 0.2 uV
50-54 MHz: 0.125 uV
|
| Selectivity: |
WIDTH: Center. VRF/u-TUNE: Off
| Mode | -6 dB | -60 dB |
| AM | 9 KHz | 18 KHz |
| FM | 15 KHz | 25 KHz |
| SSB | 2.4 KHz | 3.6 KHz |
| CW/RTTY/PKT | 500 Hz | 750 Hz |
|
| Image rejection: | 70 dB (10-160 m ham bands) |
| AF output power / speaker: | 2.5 W at 10% distortion / 4 ohm |
| External speaker connector: | 3.5 mm, 4-8 ohm |
|
|
|
|
| TRANSMITTER SECTION |
| RF output power: |
| HF | 6 m |
|---|
| AM: | 10-100 W | 10-100 W |
| FM: | 10-400 W | 10-400 W |
| SSB (PEP): | 10-400 W | 10-400 W |
| SSB (Class A): | 10-100 W | 10-100 W |
| CW: | 10-400 W | 10-400 W |
|
| Modulation system: |
AM: Low-level (Early stage)
FM: Variable reactance
SSB: Balanced
|
| Max FM deviation (Factory set): | Normal: ±5 KHz
Narrow: ±2.5 KHz |
| Spurious emissions: | Better than -60 dB (HF)
Better than -70 dB (6 m) |
| Microphone impedance / connector: |
Front: 200 ohm to 10 Kohm (600 ohm nominal) / 3-pin (XLR, balanced)
Back: 200 ohm to 10 Kohm (600 ohm nominal) / 8-pin (Metal locking ring connector)
|
| Microphone input level: | ? mV |
|
|
|
|
| MISCELLANEOUS |
| Manufactured: | Japan, 2005-20xx (Discontinued) |
| Additional info: | |
| Related documents: |
User manual (25.3 MB)
Service manual (39.1 MB)
|
| Modifications and fixes: | |
| Reviews: | |
| Options / Accessories: |
FH-2
FPS-9000H
MD-100A8X
MD-200A8X
MH-31B8
MTU-30/20
MTU-80/40
MTU-160
SP-9000
TFT-9000
VL-1000
YH-77STA
|
Remote control keypad
External power supply with dual speakers & filters
Desk microphone
Ultra-high fidelity desk microphone
Hand microphone
u-Tuning unit. 30 & 20 m
u-Tuning unit. 80 & 40 m
u-Tuning unit. 160 m
External speaker with filters & dual speakers
6.5" TFT display unit. 800x480 pixels
Linear amplifier
Lightweight headphones
|
|
