RigPix logo

Yaesu logo


Back to main

Back to Yaesu

Next HF and more


Copyright logo


Last modified 2024-07-03

Valid HTML 4.01 Transitional

Yaesu FTDX-9000 Contest

A picture of FTdx-9000 Contest

SPECIFICATIONS

GENERAL
Type:Amateur HF/VHF transceiver
Frequency range: TX: 10-160 m + WARC / 50-54 MHz
RX: 0.03-60 MHz
Tuning steps:1 / 10 Hz (AM/SSB/CW)
100 Hz (FM)
Frequency stability:±0.03 ppm @ -10 to +60°C (14 to 140°F), after 5 minutes warmup
Mode:AM / FM / SSB / CW / RTTY / Packet
Channels / memory management: 99 regular
5 QMB
9 scan edge pairs (PMS)
Non-volatile EEPROM storage
(The antenna tuner memory requires a CR2032 lithium battery backup)
Repeater shift / offset:10 m: 0-1 MHz in 10 KHz steps
6 m: 0-4 MHz in 10 KHz steps
Power supply:Mains: 90-264 VAC (3-pin IEC C14 connector)
Current drain / power consumption:RX: Max 120 VA
TX: Max 720 VA
Antenna impedance / connector: 50 ohm / Four SO-239 + Two SO-230 (RX only)
(16.7-150 ohm HF and 25-100 ohm 6 m with ATU on)
Dimensions (W*H*D):518*165*438 mm (20.4*6.5*17.3")
Weight:30 Kg (66 lb)
Other features: Data port. PS/2 keyboard jack. Direct I/O sound card connections. 32-bit IF DSP.
CAT control. CTCSS/PL. VOX. IP3 better than +40 dBm! Twin identical RX option.




RECEIVER SECTION
Receiver system: Triple conversion superheterodyne
1st IF: 40.455 MHz (VFO-A) - 40.450 MHz (VFO-B option)
2nd IF: 455 KHz (VFO-A) - 450 KHz (VFO-B option)
3rd IF: 30 KHz (24 KHz for FM)
Sensitivity: AM (10 dB S+N//N, 6 KHz BW)
0.1-1.8 MHz: 3.2 uV
1.8-30 MHz: 2 uV
50-54 MHz: 1 uV
FM (12 dB SINAD)
28-30 MHz: 0.5 uV
50-54 MHz: 0.35 uV
SSB/CW (10 dB S/+N/N, 2.4 KHz BW)
0.1-50 MHz: 2 uV
HF ham bands: 0.2 uV
50-54 MHz: 0.125 uV
Selectivity: WIDTH: Center. VRF/u-TUNE: Off
Mode-6 dB-60 dB
AM9 KHz18 KHz
FM15 KHz25 KHz
SSB2.4 KHz3.6 KHz
CW/RTTY/PKT500 Hz750 Hz
Image rejection:70 dB (10-160 m ham bands)
AF output power / speaker:2.5 W at 10% distortion / 4 ohm
External speaker connector:3.5 mm, 4-8 ohm




TRANSMITTER SECTION
RF output power:

HF6 m
AM:5-75 W5-75 W
FM:5-200 W5-200 W
SSB (PEP):5-200 W5-200 W
SSB (Class A):5-75 W5-75 W
CW:5-200 W5-200 W
Modulation system: AM: Low-level (Early stage)
FM: Variable reactance
SSB: Balanced
Max FM deviation (Factory set):Normal: ±5 KHz
Narrow: ±2.5 KHz
Spurious emissions:Better than -60 dB (HF)
Better than -70 dB (6 m)
Microphone impedance / connector: Front: 200 ohm to 10 Kohm (600 ohm nominal) / 3-pin (XLR, balanced)
Back: 200 ohm to 10 Kohm (600 ohm nominal) / 8-pin (Metal locking ring connector)
Microphone input level:? mV




MISCELLANEOUS
Manufactured:Japan, 2005-20xx (Discontinued)
Additional info:
Related documents: User manual (8 MB)
Service manual (39.1 MB)
Modifications and fixes:
Reviews:
Options / Accessories:
DMU-9000
FH-2
FPS-9000H
MD-100A8X
MD-200A8X
MH-31B8
MTU-30/20
MTU-80/40
MTU-160
RXU-9000
SP-9000
TFT-9000
VL-1000
VRF-9000
YH-77STA
Data management unit
Remote control keypad
External power supply with dual speakers & filters
Desk microphone
Ultra-high fidelity desk microphone
Hand microphone
u-Tuning unit. 30 & 20 m
u-Tuning unit. 80 & 40 m
u-Tuning unit. 160 m
Dual receive unit
External speaker with filters & dual speakers
6.5" TFT display unit. 800x480 pixels
Linear amplifier
VRF sub receiver unit for RXU-9000
Lightweight headphones
A rear picture of FTdx-9000 Contest