RigPix logo

CB/Freeband logo


Back to main

Back to CB & "Freeband"

Next mobile


Galaxy logo


Copyright logo


Last modified 2024-07-21

Valid HTML 4.01 Transitional

Galaxy DX-95T2 "Big rig series"

A picture of Galaxy DX-95T2 Big rig series

SPECIFICATIONS

GENERAL
Type:Citizen band / "Freeband" / Export transceiver
Frequency range: Export mode
25.165-28.755 MHz
10 m mode
28.315-28.755 MHz
Channels / tuning steps:320
Mode:AM / FM / SSB
Frequency control:PLL (RCI145106)
Frequency stability:0.001% @ -30 to +50°C (-22 to +122°F)
Clarifier or Delta tune:Coarse: ±6 KHz
Fine: ±1 KHz
Power supply:13.8 VDC (6-pin Molex jack, 4 pins actually used)
Current drain / power consumption:RX: ? mA
TX: ? A
Antenna impedance / connector:50 ohm / SO-239
Dimensions (W*H*D):197*73*260 mm (7.75*2.88*10.25")
Weight:2.72 Kg (6 lb)
Other features: PA. ANL/NB. Talkback. Echo chamber. Dimmer. SWR-meter.
Roger beep. +10 KHz switch. Illuminated "StarLite" faceplate.




RECEIVER SECTION
Receiver system: Single conversion superheterodyne (SSB)
IF: 10.695 MHz
Double conversion superheterodyne (AM/FM)
1st IF: 10.695 MHz
2nd IF: 455 KHz - Ceramic filter: Murata CFW455H
Sensitivity: AM: 0.5 uV (10 dB S+N/N)
FM: 0.25 uV (12 dB S+N/N)
SSB: 0.25 uV (10 dB S+N/N)
Selectivity:
Image rejection:50 dB
AF output power / speaker:2.5 W at 10% distortion / 8 ohm
External speaker connector:3.5 mm (TS), 4-8 ohm




TRANSMITTER SECTION
RF output power: AM/FM: 2-50 W
SSB: Max 150 W (PEP)
Modulation system:
FM deviation (Factory set):±? KHz
Spurious emissions:Better than -50 dB
Microphone impedance / connector:? ohm / 4-pin (Male locking ring jack)
Microphone input level:? mV




MISCELLANEOUS
Manufactured:Taiwan, 200x-20xx (Discontinued)
Main PCB: EPT690010D by Ranger
Single sided with through-hole components
Sub PCBs: EPA010012D - 150 W RF amplifier board
EPA010020B - SWR bridge board
EPA010030A - Amp feedback board
EPT091V30A - Counter and channel selector board
EPT091V41A - Meter board
EPT91V100Z - Modulation LED board
EPT095T30Z - Switch and display board
EPT095T40Z - VR board
EPT0SSB51J - Echo board
EPT91V120Z - LED board
EPT91V131Z - EL driver board
Additional info:
Related documents: User manual (209 KB)
AF amplifier: TA7222AP
Primary RF driver: 2SC2166 (Early)
Primary RF final: 2SC2312 (Early)
Primary RF driver: IRF520 (Later)
Primary RF final: IRF520 (Later)
150 W RF amplifier finals: Two 2SC2290
Approval / Market:
Sams Photofact #:None
Modifications and fixes:
Reviews:
Options / Accessories:
- -