Kenwood TM-G707 Expanded RX/TX Remove the detachable front panel from the transceiver. Remove the bottom case. Place the transceiver upside down with the antenna jack towards you. In the upper right corner, you will find a small vertical PCB (behind the display adaptor). On this PCB is a group of SMD 0-ohm resistors, numbered 0, 1, 2 and 3. Remove resistor 0 for the following extended RX bands: 118-136 MHz (AM) 136-174 MHz 300-400 MHz 400-520 MHz 800-999 MHz Remove resistor 3 for the following extended TX bands: 136-174 MHz 400-520 MHz Removing these two resistors will also yield an extra menu item, number 0, which controls the AM/FM behavior.