RigPix logo

Icom logo


Back to main

Back to Icom

Next HF and more


Copyright logo


Last modified 2024-08-24

Valid HTML 4.01 Transitional

Icom IC-7760

A picture of Icom IC-7760

SPECIFICATIONS

GENERAL
Type:Amateur HF/VHF transceiver
Frequency range: TX: 10-160 m + WARC / 6 m (Also 60 m for USA and 136 KHz for Europe)
RX: 0.03-60 MHz
Tuning steps:Down to 1 Hz
Frequency stability:Less than ±0.5 ppm @ 0 to 50°C (32 to 122°F)
Mode:AM / FM / SSB / CW / RTTY / PSK31 and 63
Channels / memory management: 99 regular
2 scan edges
Repeater shift / offset:
Power supply: RF deck
Mains: 90-264 VAC (3-pin IEC C14 connector)
Control head
15 VDC (Male barrel jack, center positive)
Current drain / power consumption:RX: 150 VA
TX: Max 800 VA
Antenna impedance / connector:16.7-150 ohm (ATU range) / Four SO-239 + two BNC (RX in/out)
Dimensions (W*H*D):Control head:340*118*104 mm (13.4*4.6*4.1")
RF deck:425*149*442 mm (16.7*5.9*17.4")
Weight:Control head:2.3 Kg (5.1 lb)
RF deck:15.8 Kg (34.8 lb)
Other features: Separate control head and RF deck. Remote control via LAN. Two touch
displays; one 7" main and one 2.4" sub. Dual identical independent
receivers and two speakers. Dual spectrum/waterfall display. Audio
scope display. Two DSP (One in the RF deck and one in the controller).

Digital preselector. A total of 15 separate bandpass filters. I/Q output.
The transmitter employs digital pre-distortion technology for a clean
output signal. Built-in auto-ATU. RTTY/PSK encoder/decoder. SD card slot.
DVI-D jack for external display.

Main/Sub band tracking function for diversity reception. VOX. Transverter
jack. Microphone equalizer. CTCSS/PL. Screen saver. USB port for RC-28,
keyboard, mouse and flash drive connection. Electronic keyer.




RECEIVER SECTION
Receiver system: Direct sampling superheterodyne
IF: 12 KHz
Sensitivity:

HF: Preamp 1 ON. 50 MHz: Preamp 2 ON.

AM (10 dB S/N. Soft filter)
0.5-1.8 MHz: 6.3 uV
1.8-30 MHz: 2 uV
6 m: 1 uV
FM (12 dB SINAD. Soft filter)
1.8-30 MHz: 0.5 uV
6 m: 0.32 uV
SSB/CW (10 dB S/N. Soft filter)
135 KHz: 1.41 uV
1.8-30 MHz: 0.16 uV
6 m: 0.13 uV
Selectivity: AM (Filter: Sharp, BW: 6 KHz)
6 KHz (-6 dB)
15 KHz (-60 dB)
FM (Filter: Sharp, BW: 15 KHz)
12 KHz (-6 dB)
20 KHz (-60 dB)
SSB (Filter: Sharp, BW: 2.4 KHz)
2.4 KHz (-6 dB)
3.6 KHz (-60 dB)
CW (Filter: Sharp, BW: 500 Hz)
500 Hz (-6 dB)
700 Hz (-60 dB)
RTTY (Filter: Sharp, BW: 500 Hz)
500 Hz (-6 dB)
700 Hz (-60 dB)
Image rejection:HF: 70 dB
6 m: 70 dB
AF output power / speaker:2 W at 10% distortion / 8 ohm
External speaker connector:Two TS minijacks (3.5 mm)




TRANSMITTER SECTION
RF output power:
AM:0.25-25 W
FM:1-200 W
SSB (PEP):1-200 W
CW:1-200 W
RTTY/PSK:1-200 W

100% duty cycle!
Modulation system: AM: Digital low power modulation
FM: Digital reactance modulation
SSB: Digital PSN modulation
Max FM deviation (Factory set):±? KHz
Spurious emissions:HF: Better than -50 dB
6 m: Better than -66 dB
Microphone impedance / connector:600 ohm / 8-pin (Male locking ring jack)
Microphone input level:? mV




MISCELLANEOUS
Manufactured:Japan, 2024-202x
Additional info:
Related documents: Brochure (3.2 MB)
Modifications and fixes:
Reviews:
Options / Accessories:
AH-730
BC-267
HM-219
IC-PW2
OPC-1465
OPC-2501
RC-28
RS-BA1
SM-30
SM-50
SP-33
SP-41
External antenna tuner
Controller AC adapter
Hand microphone with up/down buttons
HF/6 m 1 KW linear amplifier
Shielded control cable
DPD feedback cable
Remote encoder
Remote control software
Desk microphone
Dynamic desk microphone
External speaker
External speaker
A picture of the Icom IC-7760 controller
A rear picture of the Icom IC-7760 controller
A picture of the Icom IC-7760 RF deck
A rear picture of the Icom IC-7760 RF deck