| GENERAL |
| Type: | Amateur HF/VHF transceiver |
| Frequency range: |
TX: 10-160 m + WARC / 6 m
RX: 0.49-30 / 44-54 MHz
(2 m option)
|
| Tuning steps: | 1 / 10 / 20 / 50 Hz |
| Frequency stability: | Standard: ±5 ppm @ 0 to 50°C (32 to 122°F) |
| Mode: | AM / FM / SSB / CW / Data / AFSK |
| Channels / memory management: |
100 regular
4 scratch pad per band
|
| Repeater shift / offset: | ±0 to 5000 KHz |
| Power supply: | 11-15 VDC (13.8 VDC nominal) |
| Current drain / power consumption: | RX: 900 mA (Single RX)
TX: Max 22 A |
| Antenna impedance / connector: | 50 ohm / SO-239 |
| Dimensions (W*H*D): | 272*102*254 mm (10.7*4*10") |
| Weight: | 3.8 Kg (8.5 lb), without options |
| Other features: |
RS-232C. Built-in PSK31/CW/RTTY decoder/encoder. Built-in keyer.
Realtime clock. Transverter interface. 1750 Hz call tone. Two IF DSP.
CTCSS/PL encoder. Graphic equalizer. VOX.
DVR option. Sub RX option.
|
|
|
|
|
| RECEIVER SECTION |
| Receiver system: |
Double conversion superheterodyne
1st IF: 8.2 MHz
2nd IF: ? KHz
|
| Sensitivity: |
HF: -136 to -138 dBm (MDS)
6 m: -143 to -144 dBm (MDS, with PR6 option)
(Specifications guaranteed only within ham bands)
|
| Selectivity: | |
| Image rejection: | 70 dB |
| AF output power / speaker: | 2.5 W at 10% distortion / 4 ohm |
| External speaker connector: | 3.5 mm |
|
|
|
|
| TRANSMITTER SECTION |
| RF output power: |
| HF | 6 m | 2 m* |
|---|
| AM: | 0.1-100 W (85 W) | 0.1-100 W (70 W) | 0.1-10 W |
| FM: | 0.1-100 W (85 W) | 0.1-100 W (70 W) | 0.1-10 W |
| SSB (PEP): | 0.1-100 W (85 W) | 0.1-100 W (70 W) | 0.1-10 W |
| CW: | 0.1-100 W (85 W) | 0.1-100 W (70 W) | 0.1-10 W |
* With 2 m option
|
| Modulation system: | |
| Max FM deviation (Factory set): | ±5 KHz |
| Spurious emissions: | HF: Better than -50 dB
6 m: Better than -60 dB |
| Microphone impedance / connector: | ? ohm / 8-pin (Metal locking ring connector) |
| Microphone input level: | ? mV |
|
|
|
|
| MISCELLANEOUS |
| Manufactured: | USA, 2007-20xx (Discontinued) |
| Additional info: | Same as the K3/10 but with the 100 W amplifier unit included |
| Related documents: |
User manual Rev.D10 (4 MB)
Manual errata Rev.D10-8 (119 KB)
|
| Modifications and fixes: | |
| Reviews: | |
| Options / Accessories: |
KAT3
KBPF3
KDVR3
KPA500
KRX3
KSSKT
KTCXO3-1
KXV3
K3EXREF
K144XV
P3
PR6
|
Internal auto-ATU with dual antenna switch
General coverage bandpass filter array
Digital voice recorder
500 W+ hi-perf 6-160 m linear amplifier
Hi-perf sub receiver
Stainless steel exterior hardware kit
High-stability TCXO. ±0.5 ppm typical
RF I/O module
External reference lock
2 m module (Requires KXV3)
Fast and sensitive panadapter with hi-res display
Ultra low-noise 6 m preamp
|
|
