RigPix logo

CB/Freeband logo


Back to main

Back to CB & "Freeband"

Next base


Uniden logo


Copyright logo


Last modified 2024-06-18

Valid HTML 4.01 Transitional

Uniden P-1000

A picture of Uniden P-1000

SPECIFICATIONS

GENERAL
Type:Citizen band transceiver
Frequency range:26.965-27.405 MHz
Channels / tuning steps:40
Mode:FM
Frequency control:PLL (TC9106BP)
Frequency stability:?%
Clarifier or Delta tune:No
Power supply:Mains: 230-240 VAC (Fixed power cord)
or 13.2 VDC (Male 3-pin jack)
Current drain / power consumption:RX: ? mA
TX: ? A
Antenna impedance / connector:50 ohm / SO-239
Dimensions (W*H*D):? mm (?")
Weight:? Kg (? lb)
Other features:PA. Tone hi-cut filter.




RECEIVER SECTION
Receiver system: Double conversion superheterodyne
1st IF: ? MHz
2nd IF: 455 KHz
Sensitivity:
Selectivity:
Image rejection:
AF output power / speaker:? W at ?% distortion / ? ohm
External speaker connector:




TRANSMITTER SECTION
RF output power: High: 4 W
Low: 400 mW
Modulation system:
Max FM deviation (Factory set):±? KHz
Spurious emissions:Better than -? dB
Microphone impedance / connector:? ohm / 4-pin (Male locking ring jack)
Microphone input level:? mV




MISCELLANEOUS
Manufactured:Taiwan and Philippines, 1984-1987 (Discontinued)
Main PCB:PA-096AA by Uniden
Sub PCBs: PA-106 - Mic jack board
PA-122 - Channel selector board
PC-312 - LED display board
PC-410 - Power supply board
PC-807 - Phone jack board
PC-808 - Speaker jack board
Additional info:
Related documents: AF amplifier: MB3712
PLL: TC9106BP
RF driver: 2SC2028
RF final: 2SC2029
Sams Photofact #:None
Modifications and fixes:
Reviews:
Options / Accessories:
- -
A rear picture of Uniden P-1000