GENERAL |
Type: | Citizen band transceiver |
Frequency range depending on version: |
Old Australian bandplan
27.015-27.225 MHz
Other
26.965-27.405 MHz
|
Channels / tuning steps depending on version: | 18 (Old Australian bandplan) 40 (Other) |
Mode: | AM / SSB |
Frequency control: | PLL (PLL02A) |
Frequency stability: | ±?% |
Clarifier or Delta tune: | ±600 Hz |
Power supply: | 13.8 VDC (Male 2-pin jack) |
Current drain / power consumption: | RX: ? mA TX: ? A |
Antenna impedance / connector: | 50 ohm / SO-239 |
Dimensions (W*H*D): | 190*64*265 mm (7.48*2.52*10.43") |
Weight: | 2.33 Kg (5.14 lb), without mounting bracket |
Other features: | PA. NB. Dimmer. SWR meter. |
|
|
|
|
RECEIVER SECTION |
Receiver system: |
Single conversion superheterodyne (SSB)
1st IF: 10.695 MHz
Double conversion superheterodyne (AM)
1st IF: 10.695 MHz
2nd IF: 455 KHz
|
Sensitivity: |
AM: 1 uV (10 dB S/N)
SSB: 0.25 uV (10 dB S/N)
|
Squelch sensitivity: |
AM: 1 uV (Threshold)
SSB: 0.7 uV (Threshold)
|
Selectivity: |
AM
6 KHz (-6 dB)
SSB
2.5 KHz (-6 dB)
|
Image rejection: | |
AF output power / speaker: | 3 W at ?% distortion / 8 ohm |
External speaker connector: | TS "Minijack" (3.5 mm), 8 ohm |
|
|
|
|
TRANSMITTER SECTION |
RF output power: |
AM: 4 W
SSB: 12 W (PEP)
|
Modulation system: |
AM: High class level B
SSB: Double balanced modulator with crystal latice filter
|
Max FM deviation (Factory set): | No FM |
Spurious emissions: | Better than -60 dB |
Microphone impedance / connector: | ? ohm / 4-pin (Male locking ring jack) |
Microphone input level: | ? mV |
|
|
|
|
MISCELLANEOUS |
Manufactured: | Japan, 19xx-19xx (Discontinued) |
Main PCB: | PTBM048AOX by Cybernet Electronics Corporation |
Sub PCBs: | |
Additional info: | |
Related documents: |
Service manual (3.5 MB)
PLL: PLL02A
AF amplifier: TA7205P
Balanced modulator: AN612
RF driver: 2SC2166
RF final: 2SC1969
|
Market(s) / Approval(s): |
Australia
Approval no: 249024
|
Sams Photofact #: | |
Modifications and fixes: | |
Reviews: | |
Options / Accessories: |
|