| GENERAL |
| Type: | Amateur VHF transceiver |
| Frequency range: |
Europe
TX: 144-146 MHz
RX: 144-146 MHz
|
| Tuning steps: | 5 / 10 / 12.5 / 20 / 25 KHz |
| Frequency stability: | ±? ppm |
| Mode: | FM |
| Channels / memory management: |
20 regular
1 call
Priority function
|
| Repeater shift / offset: | ±600 KHz |
| Power supply: | 7-12 VDC (Depending on battery pack) |
| Current drain / power consumption: | RX: ? mA
TX: 900 mA @ 3 W output power |
| Antenna impedance / connector: | 50 ohm / BNC |
| Dimensions (W*H*D): | 57*142*32 mm (2.24*5.59*1.26") |
| Weight: | 350 g (12.35 oz) |
| Other features: |
CTCSS/PL encoder. DTMF keypad and DSQ paging.
1750 Hz tone call.
|
|
|
|
|
| RECEIVER SECTION |
| Receiver system: |
Double conversion superheterodyne
1st IF: 55.05 MHz
2nd IF: 455 KHz
|
| Sensitivity: | 0.18 uV (12 dB SINAD) |
| Selectivity: | 15 KHz (-6 dB)
30 KHz (-60 dB) |
| Image rejection: | |
| AF output power / speaker: | 250 mW at 10% distortion / 8 ohm |
| External speaker connector: | |
|
|
|
|
| TRANSMITTER SECTION |
| RF output power: |
| High
@12V | High
@7.2V | Low
@12V | Low
@7.2V |
|---|
| 2 m: | 5 W | 2 W | 500 mW | 200 mW |
|
| Modulation system: | Variable reactance |
| Max FM deviation (Factory set): | ±5 KHz |
| Spurious emissions: | Better than -60 dB |
| Microphone impedance / connector: | ? ohm / ?-pin |
| Microphone input level: | ? mV |
|
|
|
|
| MISCELLANEOUS |
| Manufactured: | Japan, 199x-200x (Discontinued) |
| Additional info: | |
| Related documents: | User manual (175 KB) |
| Modifications and fixes: | |
| Reviews: | |
| Options / Accessories: |
EBC-1
EBP-10N
EBP-12N
EDC-17
EDC-18
EDC-21
EDC-22
EJ-6U
EME-4
EME-6
EME-10
EMS-2
ESC-10
|
Belt clip
NiCd battery pack. 7.2 V, 700 mAh
NiCd battery pack. 12 V, 700 mAh
Wall charger for 7.2 V packs (220 VAC)
Wall charger for 12 V packs (220 VAC)
Wall charger for 7.2 V packs (120 VAC)
Wall charger for 12 V packs (120 VAC)
Tone squelch unit (CTCSS/PL decoder)
Earphone-microphone
Earphone
Headset with VOX & PTT
Speaker-microphone
Soft case, for use with EBP-10N
|
|
